ClearView AVS-PTZ-HD2-C Manual De Propietario
18
IDLE MOTION
：OFF
IDLE TIME
：10MIN
IDLE MOTION ：NONE
PARAMETER ：NONE
BACK EXIT
CALL：Here is to activate pattern. Input pattern number, move the cursor to CALL and click confirm
button, system begins running pattern.
STOP: Here is to stop current pattern. Input pattern number, move the cursor to STOP and click
confirm button. System stops current pattern.
BACK: Go back to previous menu.
EXIT: Log out system menu.
EXIT: Log out system menu.
Note:
The dwell time between two orders should be less than one minute, otherwise system will set to
The dwell time between two orders should be less than one minute, otherwise system will set to
default value as one minute.
After click PROGRAM STOP, do not click CALL button before icon “●” disappears completely.
Any manual operation during the pattern procedure will terminate current dome pattern operation.
Any manual operation during the pattern procedure will terminate current dome pattern operation.
3.4.4.6 Idle Motion
Figure 3-27 Idle motion
When there is no available command for specified time, dome automatically goes on the previous set
functions.
IDLE MOTION：There are two modes ON/OFF. Please use left/right key to set.
IDLE TIME: System idle period. Please use the left/right button on the keyboard or in the speed
IDLE MOTION：There are two modes ON/OFF. Please use left/right key to set.
IDLE TIME: System idle period. Please use the left/right button on the keyboard or in the speed
dome terminal menu to set.
IDLE MOTION：There are several functions you can select:
NONE/PRESET/SCAN/TOUR/PATTERN. Please use the left/right button on the keyboard or in the
speed dome terminal menu to set.
PARAMETER: It is to set idle motion SN. System can implement the corresponding action when it is
idle for the specified period. Click the left/right button to set.
SAVE：Move the cursor to SAVE and click confirm button to save current setup.
BACK: Go back to previous menu.
EXIT: Log out system menu.
BACK: Go back to previous menu.
EXIT: Log out system menu.
3.4.4.7 Privacy Mask
Move the cursor to PRIVACY MASK and click confirm button, system goes to privacy mask setup
interface.
interface.
Figure 3-28 Privacy mask
Figure 3-29 Privacy mask-2
Note:
For security reasons, please set privacy zone a little bit larger than the privacy object size.
Each time, after modifications you need to move the cursor to SAVE button and then click confirm
For security reasons, please set privacy zone a little bit larger than the privacy object size.
Each time, after modifications you need to move the cursor to SAVE button and then click confirm
button to get all setup activated. Otherwise, privacy zone may not move correspondingly with the
object.
PRIVACY NO ： 1
PRIVACY MASKING ：OFF
SETTING
BACK EXIT
RESIZE ：
↑
SAVE
BACK EXIT