Marantz PM-10 Manual De Propietario
n Desired sound does not come out
Symptom
Cause / Solution
Page
No sound comes out of a specific
speaker.
0
Check that speaker cables are properly connected.
0
Adjust the left and right channel balance.
The left and right of stereo sound is
reversed.
0
Check whether the left and right speakers are connected to the correct speaker terminals.
n Sound is interrupted or noise occurs
Symptom
Cause / Solution
Page
When playing a record, the sound is
distorted.
0
Adjust to a proper needle pressure.
-
0
Check the tip of the needle.
-
0
Replace the cartridge.
-
When playing a record, a humming
noise comes out of the speakers.
0
Check that the turntable is connected correctly.
0
If there is a TV or AV device near the turntable, such devices may affect the playback sound. Install the turntable in a location as far
away as possible from the TV or other AV devices.
-
When playing a record, a humming
noise comes out of the speakers when
the volume is high. (Howling
phenomenon)
0
Install the turntable and speakers as far from each other as possible.
0
The vibrations from the speakers are being transmitted to the player through the floor. Use cushions, etc., to absorb the speakers’
vibrations.
-
Error messages
When multiple amplifiers are connected by F.C.B.S., the error messages described in the table below may be displayed on the display. In such a case, ID number setting or remote cable
Indication
Meaning
Cause / Solution
ERROR 02
Multiple amplifiers take ID No.2.
0
Assign different ID numbers to the amplifiers.
ERROR 03
Multiple amplifiers take ID No.3.
ERROR 04
Multiple amplifiers take ID No.4.
ERROR 11
The amplifiers with ID No.2-4 cannot communicate with the amplifier with ID No.1.
0
If the amplifier with ID No.1 is not on, turn it ON.
0
Check that the remote cable is properly connected.
ERROR 12
The amplifier with ID No.1 cannot communicate with the amplifiers with ID No.2-4.
0
If multiple amplifiers take ID No.1, set ID numbers properly.
0
If the amplifier with ID No.1 is connected to the amplifier with ID No.0, set ID
numbers properly.
0
Check that the remote cable is properly connected.
ENGLISH
26
Overview
Connections
Playback
Settings
Tips
Appendix