Magicard 3663-0001 Manual De Usuario

PRINTER ERROR CODES

PP_1.48 ERROR CODES

CODE

REASON

SOLUTION

104:

ERR_FPGA_PROGRAMMING_ERROR

Error code 104.0

Reason: While preparing to update the FPGA, the incoming bit stream file size was wrong

for the fitted FPGA part (LFXP2-8E). This is probably due to a corrupted FPGA bit stream file.

Press "Cancel" and try again. Contact

your printer supplier if problem persists.

Error code 104.1

Reason: While preparing to update the FPGA, the incoming bit stream file size was wrong

for the fitted FPGA part (LFXP2-5E). This is probably due to a corrupted FPGA bit stream file.

Press "Cancel" and try again. Contact

your printer supplier if problem persists.

Error code 104.2

Reason: While preparing to update the FPGA, the device ID read from the fitted FPGA was

not a recognised one. This is probably either due to a SPI comms failure between the

processor and FPGA, or a faulty FPGA.

Press "Cancel" and try again. Contact

your printer supplier if problem persists.

Error code 104.3

Reason: While preparing to update the FPGA, the printer was unable to initialise SPI

comms with the FPGA. This is probably either due to a SPI bus problem between the

processor and FPGA, or a faulty FPGA.

Press "Cancel" and try again. Contact

your printer supplier if problem persists.

Error code 104.5

Reason: While attempting to erase the FPGA prior to reprogramming, the printer was

informed by the FPGA that its erase cycle failed. This is probably either due to faulty SPI

comms between the processor and FPGA, or a faulty FPGA.

Press "Cancel" and try again. Contact

your printer supplier if problem persists.

Error code 104.7

Reason: While writing a new bit stream file into the FPGA, the processor didn't receive

confirmation from FPGA that it had finished writing one of the rows of data. This is probably

either due to faulty SPI comms between the processor and FPGA, or a faulty FPGA.

Press "Cancel" and try again. Contact

your printer supplier if problem persists.

Error code 104.8

Reason: While attempting to verify a new bit stream file just written to the FPGA, the

processor found that one of the lines of data read back from the FPGA's internal flash did

not match the corresponding line of data in the new bit stream file. This is probably either

due to faulty SPI comms between the processor and FPGA, or a faulty FPGA.

Press "Cancel" and try again. Contact

your printer supplier if problem persists.

Error code 104.10

Reason: While attempting to finalise the reprogramming of the FPGA, the processor failed

to receive confirmation from the FPGA that finalisation was successful. This is probably

either due to faulty SPI comms between the processor and FPGA, or a faulty FPGA.

Press "Cancel" and try again. Contact

your printer supplier if problem persists.

Error code 104.11

Reason: While attempting to refresh the FPGA after reprogramming, the processor failed

to receive confirmation from the FPGA that the refresh process completed successfully. This

is probably either due to faulty SPI comms between the processor and FPGA, or a faulty

FPGA.

Press "Cancel" and try again. Contact

your printer supplier if problem persists.