Magicard 3663-0001 사용자 설명서
34
PRINTER ERROR CODES
PP_1.48 ERROR CODES
CODE
REASON
SOLUTION
104:
ERR_FPGA_PROGRAMMING_ERROR
Error code 104.0
Reason: While preparing to update the FPGA, the incoming bit stream file size was wrong
for the fitted FPGA part (LFXP2-8E). This is probably due to a corrupted FPGA bit stream file.
Press "Cancel" and try again. Contact
your printer supplier if problem persists.
Error code 104.1
Reason: While preparing to update the FPGA, the incoming bit stream file size was wrong
for the fitted FPGA part (LFXP2-5E). This is probably due to a corrupted FPGA bit stream file.
Press "Cancel" and try again. Contact
your printer supplier if problem persists.
Error code 104.2
Reason: While preparing to update the FPGA, the device ID read from the fitted FPGA was
not a recognised one. This is probably either due to a SPI comms failure between the
processor and FPGA, or a faulty FPGA.
Press "Cancel" and try again. Contact
your printer supplier if problem persists.
Error code 104.3
Reason: While preparing to update the FPGA, the printer was unable to initialise SPI
comms with the FPGA. This is probably either due to a SPI bus problem between the
processor and FPGA, or a faulty FPGA.
Press "Cancel" and try again. Contact
your printer supplier if problem persists.
Error code 104.5
Reason: While attempting to erase the FPGA prior to reprogramming, the printer was
informed by the FPGA that its erase cycle failed. This is probably either due to faulty SPI
comms between the processor and FPGA, or a faulty FPGA.
Press "Cancel" and try again. Contact
your printer supplier if problem persists.
Error code 104.7
Reason: While writing a new bit stream file into the FPGA, the processor didn't receive
confirmation from FPGA that it had finished writing one of the rows of data. This is probably
either due to faulty SPI comms between the processor and FPGA, or a faulty FPGA.
Press "Cancel" and try again. Contact
your printer supplier if problem persists.
Error code 104.8
Reason: While attempting to verify a new bit stream file just written to the FPGA, the
processor found that one of the lines of data read back from the FPGA's internal flash did
not match the corresponding line of data in the new bit stream file. This is probably either
due to faulty SPI comms between the processor and FPGA, or a faulty FPGA.
Press "Cancel" and try again. Contact
your printer supplier if problem persists.
Error code 104.10
Reason: While attempting to finalise the reprogramming of the FPGA, the processor failed
to receive confirmation from the FPGA that finalisation was successful. This is probably
either due to faulty SPI comms between the processor and FPGA, or a faulty FPGA.
Press "Cancel" and try again. Contact
your printer supplier if problem persists.
Error code 104.11
Reason: While attempting to refresh the FPGA after reprogramming, the processor failed
to receive confirmation from the FPGA that the refresh process completed successfully. This
is probably either due to faulty SPI comms between the processor and FPGA, or a faulty
FPGA.
Press "Cancel" and try again. Contact
your printer supplier if problem persists.