Meru Networks Inc. AP433E Manual De Usuario

 Check AP400 LED Activity 

© 2010 Meru Networks, Inc.

Installing AP400 15

Verify that the AP400 is unlocked using the locking key.

Brace your hand against the back of the main support bar and press the AP400 against the square 
bracket in a similar manner to that indicated in 

.

Twist until the AP400 clicks into place. If desired, you can now lock the AP using the locking key.

Mount the bracket and AP in the desired location by sliding the support arms onto the ceiling T-bars.

For each antenna, loosen the knurled ring at the base of the antenna, point the antenna down, then 
retighten the ring.

Connect one end of the PoE Ethernet cable to the Ethernet connector.

Check that the AP400 is operating correctly before replacing the ceiling tile. Verify correct 
operating using the LEDs, as shown in 

.

When AP400 first connects to the controller (and any time the access point is rebooted), the AP initial-
izes and is then programmed by the controller. When the AP first powers up, all LEDs are green.

After the AP400 is connected, check the status of the LEDs. The functions of the LEDs are described 
below.

Be sure to connect the Ethernet cable to the Ethernet port; the cable can 

mistakenly be plugged into the Console port. If you do this. the AP won’t power up.

Use a shielded Cat 5e (or greater)

 

Ethernet cable in order to comply with 

international electromagnetic emissions limits.

LEDs

00259