Diffraction Limited MD1 Manual De Usuario
MaxDome
8
Rotation Controller Installation
Tools required:
•
Electric drill
•
Small Phillips screwdriver
•
Small slotted screwdriver
•
Nut driver set
Controller Board
The controller card is shown below. Note that the Rotation Controller and the
Shutter Controller boards are identical.
Shutter Controller boards are identical.
Dome Controller Circuit Card
The circuit card is normally mounted in the corner of the fiberglass box next to
the motor assembly. To mount the card, drill four 1/8” mounting holes in the box.
The holes are spaced 2” apart vertically and 3-9/16” apart horizontally.
Refer to the picture below for the following steps. Put one washer on each screw
and insert the screws into the four holes from the outside of the box. Put another
washer on each screw from inside the box, and then attach a nut and tighten
firmly to the box.