Diffraction Limited MD1 사용자 설명서

MaxDome 

8 

Tools required: 

• 

Electric drill 

• 

Small Phillips screwdriver 

• 

Small slotted screwdriver 

• 

Nut driver set 

 

The controller card is shown below. Note that the Rotation Controller and the 
Shutter Controller boards are identical.  
 

 

Dome Controller Circuit Card 

 
The circuit card is normally mounted in the corner of the fiberglass box next to 
the motor assembly. To mount the card, drill four 1/8” mounting holes in the box. 
The holes are spaced 2” apart vertically and 3-9/16” apart horizontally.  
 
Refer to the picture below for the following steps. Put one washer on each screw 
and insert the screws into the four holes from the outside of the box. Put another 
washer on each screw from inside the box, and then attach a nut and tighten 
firmly to the box.