Video King Gaming Systems Inc. TRANS-1 Manual De Usuario
June 2004
RF Install Guide
e
-BOS
TM
2.1.x
Page 11 of 11
Software Configuration Checklist
Software Configuration Checklist
On the PowerServer machine, install PowerServer (select a TCP/IP-based RF
install.)
install.)
If the PowerServer machine is connected to a corporate network, then in
PowerConfig under the PowerServer tab, change the Network Address from the
default of DISCOVER to 192.168.8.0.
PowerConfig under the PowerServer tab, change the Network Address from the
default of DISCOVER to 192.168.8.0.
On the PowerServer machine, under Services, ensure that the pbkRFServer
service is started.
service is started.
On the PowerPlay machine, perform a network install of PowerPlay. If there is an
existing PowerPlay installation with a different e-BOS version from that which is
installed on the PowerServer, perform an upgrade install.
existing PowerPlay installation with a different e-BOS version from that which is
installed on the PowerServer, perform an upgrade install.
Under Services, if the pbkFileControlServer service exists, set its Startup Type to
Disabled.
Disabled.
In
PowerConfig under the PowerPlay tab, set Desk-Server Mode to STRICT, and
set the Server IP Address to 192.168.8.10.
Reset the Base Station. After 30 seconds, check all remote transmitters for green
lights (these lights indicate that RFServer has located the transmitters.)
lights (these lights indicate that RFServer has located the transmitters.)
On the PowerServer machine, in PowerEdit, ensure that a jurisdictionally-supported
RF Mode is selected for each session.
RF Mode is selected for each session.
Share C: on the server (this will allow the help desk to dial-in through the PowerPlay
desk.)
desk.)