BMI Technologies Inc. VUI00 Manual De Usuario
DRAFT G FORCE PLUS & G FORCE PLUS RF Instruction Manual
Nov 2005
16
Doc #RF1 Rev.2
Prevent movement/vibration of the metal connector located between the short black and long
copper-colored antenna cables by securing them and protecting the connector if necessary.
3. Supply the Transceiver with 110v power.
Plug the power supply of the AC adaptor into a standard 110v outlet.
Connect the other end of the adaptor to the Transceiver.
Connect the other end of the adaptor to the Transceiver.
4. Install and connect the Host Cable (Host Transceiver only).
Feed the Host Cable between the Host Transceiver and the computer running the software.
Plug the Host Cable’s 6-pin male connector into the 6-pin female receptacle on the Host
Plug the Host Cable’s 6-pin male connector into the 6-pin female receptacle on the Host
Transceiver.
Secure the connector.
Secure the Host Cable within 12” of the connector to prevent accidental disconnection.
Secure the Host Cable within 12” of the connector to prevent accidental disconnection.
5. Connect the Host Cable and the Signal Converter (Host Transceiver only).
Connect the individual wires in the Host Cable to the Signal Converter as shown in the diagram
below, matching the labeling on the wires and the Converter
6. Connect the Host Transceiver and the computer.
Insert the Signal Converter’s 9-pin female receptacle into the computer’s 9-pin serial port.