BMI Technologies Inc. VUI00 Manual De Usuario
DRAFT G FORCE PLUS & G FORCE PLUS RF Instruction Manual
Doc #RF1 Rev.2
15
Nov 2005
Component Overview
Installation Steps
Follow the steps in the order below and refer to diagram in
Component Overview
.
1. Mount the Transceiver in the selected location.
Note: This device exceeds the FCC/IC requirements for RF exposure when the antenna used for
this transmitter has a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter which is closer than 20
cm. The installer of this radio equipment must ensure that the antenna is located or pointed such
that it does not emit RF field in excess of Health Canada limits for the general population as
indicated by Safety Code 6.
located or operating in conjunction with any other antenna or transmitter which is closer than 20
cm. The installer of this radio equipment must ensure that the antenna is located or pointed such
that it does not emit RF field in excess of Health Canada limits for the general population as
indicated by Safety Code 6.
Note: The provided antenna, which operates in the 902 to 928 MHz frequency band, and antenna
extension cable, must be used with the G FORCE PLUS RF Vehicle Monitor. No substitutions
are allowed.
are allowed.
The optimal location for a Transceiver and antenna is:
Where it will be safe from environmental hazards, possible impacts, and vandalism,
As high as possible from the floor,
At least two feet away from any large metal mass for best communications results.
As high as possible from the floor,
At least two feet away from any large metal mass for best communications results.
Use the base of the Transceiver as a template to drill four ¼-inch holes in the selected location
and attach the Transceiver using the hardware provided.
2. Mount and connect the antenna.
Attach the metal bracket provided to the selected location so the antenna will be vertical.
Insert the antenna into the bracket slot and secure the antenna by tightening the nut.
Insert the antenna into the bracket slot and secure the antenna by tightening the nut.