Precor PRCR0111 Manual De Usuario
Installing the Control Display
31
Cable
Connector Type
Circuit
Connector
Location
Connector
Location
Ethernet (LAN)
Eight-contact modular,
on round black cable
on round black cable
Video in
Coaxial
Power Two-contact
plug,
polarized and latched
Data from base
unit
unit
Eight-contact modular,
on flat gray cable
on flat gray cable
Heart rate
sensors
sensors
4-connector strip,
keyed
keyed
Safety (stop) key
(treadmills only)
(treadmills only)
Two-contact strip, NOT
keyed or polarized
keyed or polarized
(the two pins
farthest to the
right)
farthest to the
right)
CSAFE Eight-contact
modular
Completing the Display Installation
(AT-1500 Display)
(AT-1500 Display)
Before you complete the final installation steps,
double-check the connections you have made. Make sure
that all cables are fully and securely connected, and that
any unneeded cables are tied back properly.
double-check the connections you have made. Make sure
that all cables are fully and securely connected, and that
any unneeded cables are tied back properly.
To complete the installation:
1. Insert the remaining
¹₂-inch flat head screws through
the holes in the display mount and thread them into
the holes in the back plate on the display. Tighten all
four screws fully.
the holes in the back plate on the display. Tighten all
four screws fully.
2. Line up the two small tabs at the bottom of the
display’s back cover with the slots at the bottom of the
display case. Insert the tabs into the slots.
display case. Insert the tabs into the slots.
3. Insert the remaining tabs on the cover with the
corresponding slots on the display case.
4. Press gently on the edges of the cover to snap it into
place.