ey Security Solutions Inc. SDC2K Manual De Usuario

The following is a list of the bits in the FLAGS column and their corresponding 
Portal Gateway status flags and definitions (Figure 157, item 12). 

The typical Wi-Q and Omnilock device status code is 00030043. This is the example 

used in the chart below.

Right 

END

CONTROLLER_IS_ASSOCIATED

Set when the Controller is first associated with 

the Portal.

CONTROLLER_IS_VALID

Set during association, after the Portal 

receives a beacon from the Controller.

Bit 2

CONTROLLER_CONFIG_REQUIRED

Set during association, cleared by Portal 

Communication Service after Controller  

configuration.

Bit 3

CONTROLLER_ASSOC_PENDING_LIF

Set during association to indicate that Portal 

requires LIF (Lock Information Frame) data.

Bit 4

CONTROLLER_BEGIN_TRANSMISSION

Set when Portal first transmits data to the 

Controller.

Bit 5

CONTROLLER_DEEP_RESET_PENDING

Portal must disassociate Controller when it 

receives the next beacon.

CONTROLLER_VALID_INTERVALS

Set when Controller interval assignment has 

been received from the PC Communication 

Service.

Bit 7

Bit 8

CONTROLLER_RETRY_LIMIT_

EXCEEDED

Set when the retry limit on any command has 

been hit; used to limit downloads to firmware 

only.

Bit 9

Bit 10

Bit 11

Bit 12

Bit 13

CONTROLLER_PREFERRED_PG_

ENABLED

Set when Controller is locked to the Portal.

Bit 14

CONTROLLER_FIRMWARE_PENDING_

DN

Set when the firmware commit has been sent 

to indicate that the disassociation is pending.

Bit 15

CONTROLLER_FIRMWARE_PENDING

Set when firmware update is scheduled for 

the Controller, cleared when firmware commit 

is sent.

CONTROLLER_REPORT_TIME 

_UPDATED

Set during association and when report time 

is updated

CONTROLLER_LIF_IS_VALID

Set when a LIF beacon is received

Left  

END

Bit 18-31