Radiolink Electronic Limited RL037T001A Manual De Usuario
CH1 CH2
R
R
L
L
Aileron operation
Elevator operation
21
18
To activate V-tail mixing:
1. Connect the left ruddervator servo to channel 2 (elevator) in the receiver and connect
the right ruddervator servo to channel 4 (rudder) in the receiver.
2. Enter the programming mode. Access the “V-TL” screen with the MODE“▲”or“▼” key.
You cannot set “V-tail” mixing when “Elevon” mixing has already been set. In order to
enable “V-tail” mixing, you first need to cancel “Elevon” mixing. However, it is allowed to use
“V-Tail” and “Flaperon” mixing simultaneously.
3. Press the DATA “+” key. This will cause the flashing “INH” display to change to a flashing
“ON” display. Now the mixing is on.
4. Next you may set the elevator. Press the SELECT key to display the “CH2” and flashing
“%” sign. Use the DATA “+” key to set the percentage of elevator travel rate from -100% to
+100%
5. Next you may set the rudder. Press the SELECT key to display the “CH4” and flashing
“%” sign. Use the DATA “+” key to set the percentage of rudder travel rate from -100% to
+100%
6. Once this mix has been activated, move the servos to their full extremes to make certain
they are not overdriving the controls. If necessary, adjust the linkages to achieve the
correct control throws.
ELVN Elevon mixing (ACRO only)
Intended for tailless, “flying wing” models such as delta wings and flying wings,
elevon mixing mixes channel 1 (aileron) to channel 2 (elevator) allowing the
elevons to operate in unison (as elevators) or in opposition (as ailerons). This
function requires that each elevon be operated by a separate servo.
To activate elevon mixing:
1. Connect the servo in the right wing to channel 2 (elevator) in the receiver and
connect the servo in the left wing to channel 1 (aileron) in the receiver.
*If necessary, use the Servo Reversing
function to achieve the correct direction of
servo throws.