Radiolink Electronic Limited RL037T001A Manuel D’Utilisation

CH1 CH2

Aileron operation

Elevator operation

To activate V-tail mixing:

1. Connect the left ruddervator servo to channel 2 (elevator) in the receiver and connect

the right ruddervator servo to channel 4 (rudder) in the receiver.

2. Enter the programming mode. Access the “V-TL” screen with the MODE“▲”or“▼” key.

You cannot set “V-tail” mixing when “Elevon” mixing has already been set. In order to

enable “V-tail” mixing, you first need to cancel “Elevon” mixing. However, it is allowed to use

“V-Tail” and “Flaperon” mixing simultaneously.

3. Press the DATA “+” key. This will cause the flashing “INH” display to change to a flashing

“ON” display. Now the mixing is on.

4. Next you may set the elevator. Press the SELECT key to display the “CH2” and flashing

“%” sign. Use the DATA “+” key to set the percentage of elevator travel rate from -100% to

+100%

5. Next you may set the rudder. Press the SELECT key to display the “CH4” and flashing

“%” sign. Use the DATA “+” key to set the percentage of rudder travel rate from -100% to

+100%

6. Once this mix has been activated, move the servos to their full extremes to make certain

they are not overdriving the controls. If necessary, adjust the linkages to achieve the

correct control throws.

ELVN Elevon mixing (ACRO only)

Intended for tailless, “flying wing” models such as delta wings and flying wings,

elevon mixing mixes channel 1 (aileron) to channel 2 (elevator) allowing the

elevons to operate in unison (as elevators) or in opposition (as ailerons). This

function requires that each elevon be operated by a separate servo.

To activate elevon mixing:

1. Connect the servo in the right wing to channel 2 (elevator) in the receiver and

connect the servo in the left wing to channel 1 (aileron) in the receiver.

*If necessary, use the Servo Reversing

function to achieve the correct direction of

servo throws.