Mitel Deutschland GmbH 68635RFP36U-01 Manual De Usuario
OM Management Portal (OMP)
181
6.9 “VIDEO DEVICES” MENU
The
Video devices panel lists all configured video devices. The device list is available in Configuration
Mode as well as in Monitor mode.
New video device entries show up automatically after they are connected to and recognized by a DECT
base station. The
New video device entries show up automatically after they are connected to and recognized by a DECT
base station. The
Plugged and State columns shows the following states:
•
/
unplugged – Video device is not connected.
•
/
plugged – Video device is connected.
•
/
started – Video device is being watched in the OM Locating application.
•
/
stopped – Video device is connected but disabled in the OMP.
The
Tag column shows the USB ID of the connected video device. The USB path column shows the
USB port number to be used, e.g. “1” is a video device connected directly to the RFP while “1.1”
indicates an indirect connection using an USB hub.
indicates an indirect connection using an USB hub.
The tasks which can be performed are mode-dependant.
Configuration mode
Monitor mode
See section
Configure: configure selected video device
in detail panel
in detail panel
Show details: show selected video
device in detail panel
device in detail panel
Delete: delete selected disconnected video
device
device
Filter: show only video device entries in
table which contains a special search string
table which contains a special search string
Filter: show only video device
entries in table which contains a
special search string
entries in table which contains a
special search string
6.9.1 CHANGING VIDEO DEVICES
Changing video devices is only possible in
Configuration Mode. To change the configuration of an
existing video device, do the following:
1 Select the appropriate video device in the video devices table.
2 In the task bar on the right of the Video devices panel click on the Configure command.
1 Select the appropriate video device in the video devices table.
2 In the task bar on the right of the Video devices panel click on the Configure command.
The video device detail panel opens.
3 Change video device parameters, see description below.
4 Press the OK button.
4 Press the OK button.
Please note:
You cannot change the configuration for a video device that is being watched
in the OM Locating application (
State column shows “active”). You must disable the video
device first by deactivating the
Active option.
The following parameters can be set in the
General tab of the Video devices panel:
•
Active: Disable this option to switch off the video device. This also switches off the status LED of the
video device immediately (if applicable).
•
Name: Enter a meaningful name for the video device.
•
Building, Floor, Room: For easier localization of the video device you can enter data in these fields.