Novatel 01018518 Manual De Usuario
68
SMART-MR10 User Manual Rev 0B
Appendix A
Technical Specifications
A.2.1
SMART-MR10 Evaluation Cable (Part Number 01018515)
The SMART-MR10 evaluation cable provided with the SMART-MR10 Development Kit, is
illustrated in Figure 27 and equipped as follows:
illustrated in Figure 27 and equipped as follows:
•
Exposed power wires (red for positive and black for negative) are connected to a 12 or 24V
vehicular power circuit (or equivalent), which must be protected by a user-supplied 5A fuse
(NovAtel recommends an automotive blade-type fuse rated for 5A with an operating voltage of
more than 36 V).
vehicular power circuit (or equivalent), which must be protected by a user-supplied 5A fuse
(NovAtel recommends an automotive blade-type fuse rated for 5A with an operating voltage of
more than 36 V).
•
Two DB-9 connectors. One of these is normally connected to a PC/laptop serial (RS-232)
communication port and another to a modem or radio transmitter, to propagate differential
corrections (refer to your user-supplied modem or radio transmitter user guide for more
information).
communication port and another to a modem or radio transmitter, to propagate differential
corrections (refer to your user-supplied modem or radio transmitter user guide for more
information).
•
Four pairs of bare wires, where the outer insulation is cut away but the wires beneath are intact.
These are provided for emulated radar, MKI, PPS, and CAN bus. See Table 7 on page 69 for their
pinouts and use. For more information on mating connectors and part numbers, see Table 9 on
page 72.
These are provided for emulated radar, MKI, PPS, and CAN bus. See Table 7 on page 69 for their
pinouts and use. For more information on mating connectors and part numbers, see Table 9 on
page 72.
This cable is RoHS compliant.
Figure 27: SMART-MR10 Evaluation Cable
+
-
MKI
ER/PPS
CAN
COM2
COM1
User Supplied
5A Fuse
5A Fuse
Tyco 23-pin
connector
connector
COM3
MODE