Wilson Electronics LLC 2B1216 Manual De Usuario
1
2
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com Mon.- Fri. Hours: 7 am to 6 pm MST.
Select a location to install the Signal Booster that is away from excessive heat, direct
1 .
sunlight, moisture and that has proper ventilation . Do not place the Signal Booster in
an air-tight enclosure .
Select a location on the top of the structure to install the Outside Antenna . Use a cell
Select a location on the top of the structure to install the Outside Antenna . Use a cell
2 .
phone in test mode to find the strongest signal from the cell tower . Visit
www.WilsonElectronics.com to find test mode function for your particular cell phone .
Run the Outside Antenna cable to the Signal Booster and attach it to the connector
Run the Outside Antenna cable to the Signal Booster and attach it to the connector
3 .
labeled “Outside Antenna .”
An external adapter is required to connect the cell phone or cellular data card to the
An external adapter is required to connect the cell phone or cellular data card to the
4 .
Signal Booster . The external adapter plugs into the included antenna extension cable
and directly into a socket on the cellular device . Run the extension cable from the
external adapter and attach it to the connector labeled “Inside Antenna” on the Signal
Booster .
Note: Be careful when plugging the connector in so as not to bend the center pins on
the connectors. Ensure all cables have a tight connection.
Before powering up the Signal Booster verify that both the Outside Antenna and the
5 .
Inside Antenna are connected and check that all connections are tight . An AC surge
protector is recommended for all installations (not included) .
Quick Installation Overview
The following steps provide a summary of the Signal Booster/antenna installation process .
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 .
Powerstrip Surge Protector
Power Supply
GSM Hi-Power
Signal Booster
Cellular Modem
Mini-Magnet
Antenna
Installation Diagram
(Figure 1)
NOTE:
It is very important to power your Signal Booster using a surge protected AC Power Strip with at least a 1000 Joule rating.
Failure to do this will void your warranty in the event of a power surge or lightning strike.