Comba Telecom Ltd. RS-5180 Manual De Usuario
R S - 5 1 8 0 C D M A 8 0 0 / 1 9 0 0 D u a l B a n d I n d o o r F i b e r O p t i c
R e p e a t e r
Comba Telecom
Edition
2.0
Date
2001-06
18 of 31
B Installed on the wall support:
1
For the convenience of marking the fixing holes on wall, first
assemble a baseplate and two wall support as shown in the
Repeating End Installation Schematic Diagram (B) (figure 3.1- 5)
to form the baseplate-w a l l s u p p o r t c omponent. The baseplate
should be removed from the well-assembled portable frame.
Note: Put the portable frame with baseplate removed
horizontally on the ground, not vertically, to ensure safety.
2
Choose an appropriate place on wall. Move the above mentione d
baseplate-wall support component to the place and mark the
positions of 2
φ
14 holes at both sides.
3
Drill 4 holes at the four positions with electric impact drill and
embed four
φ
10x80mm expansion screws.
4
Lift the baseplate- wall support component. Place it stably on
the wall through the 4 holes using flat gasket, spring washer
and nuts.
5
Remove the baseplate of the baseplate-wall support component.
6
Assemble the portable frame as the description about the
assembly of portable frame.
7
Lift the portal frame. P lace it stably on the wall support through
the 4 holes on two baseplates and 2 wall supports with
hexagonal M10 screws, flat gasket, spring washer and nuts.
Portal frame is installed well.