VDA MULTIMEDIA SPA 65000W0 Manual De Usuario
Manual Setup - Remote Control Unit
All RCU configurations are set using the programming mode feature.
Choosing the correct code (s) is crucial, once identified, the button assignment code(s) must
be set into the RCU. This chapter will guide the user for the manual setup of the remote
control.
There are several advanced features to simplify cloning / loading of the RCU configuration for
multiple rooms, please refer to 'Advanced: IR Configuration' on page 24.
Choosing the correct code (s) is crucial, once identified, the button assignment code(s) must
be set into the RCU. This chapter will guide the user for the manual setup of the remote
control.
There are several advanced features to simplify cloning / loading of the RCU configuration for
multiple rooms, please refer to 'Advanced: IR Configuration' on page 24.
RCU programming Mode
To enter programming mode hold down both
+
buttons (2.5 Seconds), until the
green LED blinks twice, please note programming mode will terminate after 10 seconds of
inactivity.
After entering programming mode, enter the 4-digit code for your TV set all 4 digits must be
entered consecutively including leading zeros. The green LED blinks twice for a correct code or
stays lit two seconds for a bad code.
inactivity.
After entering programming mode, enter the 4-digit code for your TV set all 4 digits must be
entered consecutively including leading zeros. The green LED blinks twice for a correct code or
stays lit two seconds for a bad code.
Test the TV functions
After the TV type code has been entered into the RCU, all numeric, on/off, colour button,
volume up/down, channel up/down, mute and source button, will emit IR commands only.
To verify correct operation, while aiming the RCU at the TV, press all relevant keys in turn and
confirm they operate as expected. If the TV does not respond correctly start again and / or try
an alternative code. Do not proceed until correct operation is verified.
volume up/down, channel up/down, mute and source button, will emit IR commands only.
To verify correct operation, while aiming the RCU at the TV, press all relevant keys in turn and
confirm they operate as expected. If the TV does not respond correctly start again and / or try
an alternative code. Do not proceed until correct operation is verified.
Re- assigning 'Key Groups' to IR/RF
After code programming, all keys are set to directly control the TV database (see key
description). Some ‘Key Groups’ must now be assigned to control the OnAir SBB and the
television according to the IPTV channel distribution or SMATV channel distribution result.
description). Some ‘Key Groups’ must now be assigned to control the OnAir SBB and the
television according to the IPTV channel distribution or SMATV channel distribution result.
The following procedure details how to assign appropriate ‘Key Group’ code(s) to the RCU.
Study the following table and select code(s) that will assign appropriate RCU key(s) and/or ‘Key
Groups’ for RF or IR control.
Study the following table and select code(s) that will assign appropriate RCU key(s) and/or ‘Key
Groups’ for RF or IR control.
Use the programming sequence (see above chapter RCU programming Mode on page 28) to
enter 4-digits code listed on the table RF-IR-Key group according to your selection. Repeat the
above sequence until all required codes for the suggested configuration have been entered.
enter 4-digits code listed on the table RF-IR-Key group according to your selection. Repeat the
above sequence until all required codes for the suggested configuration have been entered.
28