Aruba Networks AP85FXLX Manual De Usuario

 

Aruba AP-85 Outdoor Access Point Series | Installation Guide

AP-85 Series Installation |

When WLAN planning is complete and the appropriate products and their placement have been determined, the Aruba 
Mobility Controller(s) must be installed and initial setup performed before the Aruba Outdoor Access Points. are deployed.

For initial setup of the Mobility Controller, refer to the ArubaOS Quick Start Guide for the software version installed on 
your controller.

Before installing your AP-85, be sure that you have the items listed in 

Table 4

.

Successful setup of an AP-85 consists of five tasks, which must be performed in the following order:

1. Verify pre-installation connectivity

2. Provision the AP-85

3. Install the AP-85

4. Verify post-installation connectivity

5. Configure the AP-85

Table 4  AP-85 Pre-Installation Checklist

z

Fast Ethernet (FE) cable of required length

z

IEEE 802.3af compliant PoE source (Aruba 
Mobility Controller or Midspan device) or DC 
power source

z

Aruba Mobility Controller configured and 
installed on the network

z

Layer 2/3 network connectivity to your AP-85

z

One of the following network services:
1. Aruba Discovery Protocol (ADP)
2. DNS server with an “A” record
3. DHCP Server with vendor specific options

z

Fiber patch cable of required length:
1. Single-mode fiber patch cable for the AP-85LX
2. Multi-mode fiber patch cable for the AP-85FX

z

AC or DC power source

z

Aruba Mobility Controller configured and installed 
on the network

z

Layer 2/3 network connectivity to your AP-85

z

One of the following network services:
1. Aruba Discovery Protocol (ADP)
2. DNS server with an “A” record
3. DHCP Server with vendor specific options

N O T E

It is important that you follow the guidelines in the previous section, 

, before attempting to set up and install an AP-85.