Hewlett Packard Enterprise Company APIN0228 Manual De Usuario

| Installation Guide

1. Slide the sealing nut over the cable (without the RJ45 connector attached to the end).
2. Slide the clamping ring over the cable.
3. Using a crimping tool, attach the shielded RJ45 connector to the end of the cable.
4. Remove the weatherproof cap on the Ethernet port. 
5. Insert the RJ45 connector to the Ethernet port.
6. Screw the clamping ring onto the Ethernet port.
7. Screw the sealing nut onto the clamping ring.

The integrated LEDs on the AP can be used to verify that the AP is receiving power and initializing 

successfully (see 

and 

). Refer to the ArubaOS Quick Start Guide for further details on 

verifying post-installation network connectivity.

Provisioning parameters are unique to each AP. These local AP parameters are initially configured on 

the controller which are then pushed out to the AP and stored on the AP itself. Aruba recommends 

that provisioning settings be configured via the ArubaOS Web UI only. Refer to the ArubaOS User 

Guide for complete details.

Configuration parameters are network or controller specific and are configured and stored on the 

controller. Network configuration settings are pushed out to the AP(s) but remain stored on the 

controller.
Configuration settings can be configured via the ArubaOS Web UI or ArubaOS CLI. Refer to the 

ArubaOS User Guide for complete details.

The cable is not included and must be purchased separately. Purchase a suitable UV-resistant, outdoor rated, 
CAT 5E or better RJ45 cable for use with the AP.

Sealing Nut

Clamping Ring

CAT 5E or Better Cable

Seals

The seals inside the clamping ring by factory default is applicable for cables with 5-8.5 mm diameter. In the 
cable gland kit, another seals is provided for use with the cables with 7-10 mm diameter.