Hewlett Packard Enterprise Company ARUBA52 Manual De Usuario
Setup & Installation
19
Chapter 2
7/29/03 FINAL DRAFT—CONFIDENTIAL
Free-Standing Placement
To place the Aruba 52 on a flat table or shelf, first attach the included non-skid foot-pads to
the bottom of the chassis.
the bottom of the chassis.
Using the Built-In Mounting Slots
The keyhole-shaped slots on the bottom of the Aruba 52 can be used to attach the device to a
wall or shelf.
wall or shelf.
To hang the Aruba 52, perform the following steps.
Install three screws in the wall or shelf as shown in
F
IGURE
2-3 Mounting Screw Specifications
If attaching the device to drywall, we recommend using appropriate wall anchors (not
included) as shown in
included) as shown in
Figure 2-4
.
C
AUTION
—
Do not place the Aruba 52 in any place where it could fall on people or
equipment. For more secure installation, use the optional mounting kit.
C
AUTION
—
Do not use the mounting slots to hang the Aruba 52 from the ceiling
or in any place where it could fall on people or equipment. For more secure installa-
tion, use the optional mounting kit.
tion, use the optional mounting kit.
1
READY
LAN
.A
.B
Orientation
7.27 cm
(2.86")
(2.86")
7.27 cm
(2.86")
(2.86")
5.5 cm
(2.17")
(2.17")
0.12"
0.27"
0.23"
0.05"
clearance
from surface
3.0
mm
5.8
mm
0.08"
0.15"
0.15"
clearance
from surface
2.0
mm
3.8
mm
clearance
from surface
1.3
mm
clearnace
from surface
7.0
mm
Maximum
Minimum
Screw/Nail Dimensions
Screw/Nail Positions
(fastened to wall or shelf)
Measuring
Point