Redline Communications Inc. AN80IC Manual De Usuario
Red
CONNEX
™
User
AN-80i
Manual
70-00072-01-05-DRAFT
Proprietary Redline Communications © 2008
Page 68 of 94
January 22, 2008
5.3.13 Set
Use the set command to view and/or change a parameter.
View a parameter:
View a parameter:
set [field] <Enter>
Change a parameter:
set [field] [value] <Enter>
Table 27: CLI - set
PTP PMP Parameter/Description
√
activekey
: Current active options key.
<active_idx> - [ 0 | 1]
√
adaptmod
: Enable or disable the adaptive modulation function.
off
- Disable
on
- Enable
When enabled, the AN-80i will automatically change the modulation to the
highest setting that can sustain a packet error rate lower than 1x10e-6. If the
packet error rate exceeds 1x10e-6, the system automatically steps down
modulation/code rate (i.e., from 16 QAM 3/4 to 16 QAM 1/2 ) to maintain the
wireless link quality.
highest setting that can sustain a packet error rate lower than 1x10e-6. If the
packet error rate exceeds 1x10e-6, the system automatically steps down
modulation/code rate (i.e., from 16 QAM 3/4 to 16 QAM 1/2 ) to maintain the
wireless link quality.
√
antgain
: Enter value for antenna gain (dBi).
When DFS is enabled, it is important that the Antenna Gain setting matches the
true antenna gain. If the antenna gain is set higher incorrectly, the AN-80i is
less sensitive to detecting interference, and is not operating in compliance with
the UK/ETSI standard.
true antenna gain. If the antenna gain is set higher incorrectly, the AN-80i is
less sensitive to detecting interference, and is not operating in compliance with
the UK/ETSI standard.
√
atpc
: Enable or disable the ATPC function. Both AN-80i units monitor Rx signal
and automatically adjust the Tx level of the transmitting system to optimize
system performance. The ATPC feature must be enabled on both ends of the
link.
system performance. The ATPC feature must be enabled on both ends of the
link.
off
- Disable
on
- Enable
This mode can be changed only if allowed by the options key. If the options key
does not allow changes: 1) value is specified by the options key, 2) executing a
set command for this field will generate an error message.
does not allow changes: 1) value is specified by the options key, 2) executing a
set command for this field will generate an error message.
√
√
autoscan
: Enable or disable the Autoscan function.
off
- Disable
on
- Enable
When enabled, the PTP Subscriber (system mode) AN-80i automatically scans
available channels to locate the current operating frequency of the PTP Sector
Controller system. Executing a set command this field on a PTP Sector
Controller will generate an error message.
available channels to locate the current operating frequency of the PTP Sector
Controller system. Executing a set command this field on a PTP Sector
Controller will generate an error message.
√
bsporten
: Sector controller Ethernet port enable.
<id>
- [id number]
<mode>
- <on/off>
√
√
buzzer
: Enable or disable the audible alignment buzzer.
off
- Disable
on
- Enable
When enabled, the rate of the tone is proportional to the receive signal strength
(faster = stronger signal).
(faster = stronger signal).
√
√
chwidth
: Enter the channel bandwidth in MHz. Valid entries are 10, 20, and 40.