CommScope Technologies LLC IPBTS-C30-1900 Manual De Usuario
Chapter 4
l
RN commissioning
Establishing a console connection
4-6
910136 Rev01.00 Standard July 2007
NOTE
The Ethernet port IP addresses are necessary only if you are downloading software using an
Ethernet connection, which is recommended. For more information, contact your network
planner.
Ethernet connection, which is recommended. For more information, contact your network
planner.
Table 4-3.
Configuration parameters
Object
Parameter
Description
Interfaces
ifAdminStatus
The desired state of the interface: up (1), down (2), or testing (3).
Note:
The testing (3) state indicates that no operational packets can be passed.
The address at the protocol layer immediately “below” the network layer in the
protocol stack.
protocol stack.
Note:
For interfaces that do not have such an address, for example, a serial
connection, the ifPhysAddress has a length of zero (0).
ifPhysAddress
SectorElements
TimingAdvance
The timing advance for the SectorElement. Range {0..255} with default 0.
ControlChannelRate
The data rate of the Control Channel of the SectorElement. Range: unknown (1),
38.4 Kbps (5), 76.8 Kbps (6) with default value unknown (1).
38.4 Kbps (5), 76.8 Kbps (6) with default value unknown (1).
PNOffset
The pn offset for the SectorElement. Range: {0..511} with a default (0).
CountryCode
The country code with which the SectorElement is associated. Range: {0..255}
with a default (0).
with a default (0).
SubnetMaskLength
The length of the subnet mask used to extract the subnet from the sector ID.
Range: {0..127} with a default (0).
Range: {0..127} with a default (0).
RouteUpdateRadius
The distance measured between the serving sector and the sector that triggered a
new route update. Range: {0..2047} with a default (0).
new route update. Range: {0..2047} with a default (0).
SectorIndex
The sector index number of the sector. Range {1..65535}.
CarrierIndex
The index of the carrier object to which this SectorElement is bound. Range:
{1..65535}
{1..65535}
Note:
The value of this attribute can be changed only when the status of this
SectorElement object is down (1).
AdminStatus
The administrative status for the SectorElement. Range: down (1), up (2),upTest
(3)
(3)