CommScope Technologies LLC IPBTS-C30-1900 Manual De Usuario

l

RN commissioning

4-18

910136 Rev01.00 Standard July 2007

For example, the following command sets the second T1 or E1 backhaul to internal 
loopback mode: >ipBts-XXX_SC>mmb f500010a 04 

2. If the backhaul links are Ethernet, enter the following CLI command:

>ipBts-XXX_SC>poke874 fenet1 13 803c

3. Run the internal backhaul test on the interface(s) you have set to internal loopback mode 

with the following CLI command: 

4. Enter the following command to start the loopback test:

>ipBts-XXX_SC>commsend <number of tests> <ports>

Where:

•

<number of tests> specifies the number times each port is to be tested. The valid 
range is between (0 – 100000).

•

<ports> specifies the names of the ports to be tested. See 

.

For example, the following command would start the loopback test for a system with two 
E1 backhaul links: >ipBts-XXX_SC>commsend 10 T1 T2

5. Evaluate the results.

After the test is complete, the following data table displays for each backhaul tested.

Number of Transmitted Frames : x

<port memory location>

f500000a 

The first T1 or E1 backhaul

f500010a 

The second T1 or E1 backhaul

f500020a 

The third T1 or E1 backhaul

f500030a 

The fourth T1 or E1 backhaul

<ports>

T1

The first T1 or E1 backhaul

T2

The second T1 or E1 backhaul

T3

The third T1 or E1 backhaul

T4

The fourth T1 or E1 backhaul

FENET1

The primary Ethernet backhaul