ConnecteDevice Limited BTG2 Manual De Usuario
PAGE 3 / 7
To maximize battery lifetime, it is recommended to recharge your headset to full
capacity only when the battery is low, since a battery has a lifetime of about 500
charging cycles.
capacity only when the battery is low, since a battery has a lifetime of about 500
charging cycles.
If you leave your headset battery empty for an extended period of time, it could
excessively discharge the battery. In this case, you may have to charge your headset
for 10 hours or more until the battery recovers and recharges completely. The
indicator light will be red at the beginning of the charge to recover the battery
capacity, then it will turn to purple for the normal charging process.
Only switch on the headset once the blue indicator light turns on, indicating the
battery has fully recovered.
excessively discharge the battery. In this case, you may have to charge your headset
for 10 hours or more until the battery recovers and recharges completely. The
indicator light will be red at the beginning of the charge to recover the battery
capacity, then it will turn to purple for the normal charging process.
Only switch on the headset once the blue indicator light turns on, indicating the
battery has fully recovered.
Do not let the battery charger plugged in the headset for more than 24h.
2. Pairing Bluetrek® G2
Before using the Bluetrek® G2 headset, you must pair it with your Bluetooth® mobile
phone. Pairing is the process of linking 2 Bluetooth® devices, so that they can
communicate.
The pairing only needs to be done once. Afterwards, every time you switch on your
headset, it will automatically connect to your mobile phone. If you pair your
Bluetooth® mobile phone with another Bluetooth® device, you will have to pair the
Bluetrek® G2 with your phone again before use.
The profile (Headset or Hands-Free) is automatically selected by the Mobile phone
during the Pairing stage.
IMPORTANT : Before pairing, all Bluetooth® devices must be switched off.
To initiate the pairing, put both the headset and the mobile phone within 0.3 meter (1
foot) from each other. Make sure there is no Wi-Fi equipment operating in the vicinity.
1. Switch on your phone and select the Bluetooth® discover mode on the Mobile
phone (See the Bluetooth® mobile phone user guide).
2. Press and hold (do not release it) the TALK button (see button 1 on page 2) for
about 7 seconds until the indicator light flashes red and blue alternatively. Then
release the TALK Button. A beep can be heard in the speaker.
3.Once the mobile phone detects the headset, a message is displayed with the
following information : “Bluetrek g2”.
4. Follow the phone instructions to accept the pairing. The PIN code (or passkey)
is 0000.
5. When the pairing is completed, the indicator light will switch to blue, and
flashes slowly.
If you haven’t started the discovery mode within 5 minutes, the headset will switch
off. You must then switch on your headset and start the pairing again.
about 7 seconds until the indicator light flashes red and blue alternatively. Then
release the TALK Button. A beep can be heard in the speaker.
3.Once the mobile phone detects the headset, a message is displayed with the
following information : “Bluetrek g2”.
4. Follow the phone instructions to accept the pairing. The PIN code (or passkey)
is 0000.
5. When the pairing is completed, the indicator light will switch to blue, and
flashes slowly.
If you haven’t started the discovery mode within 5 minutes, the headset will switch
off. You must then switch on your headset and start the pairing again.