Cisco Systems 102053 Manual De Usuario
C I S C O C O N F I D E N T I A L - D r a f t 2
3-4
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-03
Chapter 3 Configuring the Access Point for the First Time
Assigning Basic Settings
Note
The Cisco part number for the DB-9 to RJ-45 serial cable is AIR-CONCAB1200. Browse to
to order a serial cable.
Step 2
Set up a terminal emulator to communicate with the access point. Use the following settings for the
terminal emulator connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
terminal emulator connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
Assigning Basic Settings
After you determine or assign the access point’s IP address, you can browse to the access point’s Express
Setup page and perform an initial configuration:
Setup page and perform an initial configuration:
Step 1
Open your Internet browser. You must use Microsoft Internet Explorer (version 5.x or later) or Netscape
Navigator (version 4.x).
Navigator (version 4.x).
Step 2
Enter the access point’s IP address in the browser address line and press Enter. An Enter Network
Password screen appears.
Password screen appears.
Step 3
Press Tab to bypass the Username field and advance to the Password field.
Step 4
Enter the case-sensitive password Cisco and press Enter. The Summary Status page appears.
shows the Summary Status page.