Cisco Systems 102053 Manual De Usuario

To browse to the access point’s Express Setup page, you must either obtain or assign the access point’s 
IP address using one of the following methods:

Connect to the access point console port and assign a static IP address. Follow the steps in the 

 to connect to the console port. 

Use a DHCP server (if available) to automatically assign an IP address. You can find out the 
DHCP-assigned IP address using one of the following methods:

Connect to the access point console port and use the show ip interface brief command to 
display the IP address. Follow the steps in the 

 to connect to the console port.

Provide your organization’s network administrator with your access point’s Media Access 
Control (MAC) address. Your network administrator will query the DHCP server using the 
MAC address to identify the IP address. The access point’s MAC address is on label attached to 
the bottom of the access point.

Use the Cisco IP Setup Utility (IPSU) to identify the assigned address. You can also use IPSU 
to assign an IP address to the access point if it did not receive an IP address from the DHCP 
server. IPSU runs on most Microsoft Windows operating systems: Windows 9x, 2000, Me, NT, 
and XP.

For information on IPSU, refer to 

. 

If you need to configure the access point locally (without connecting the access point to a wired LAN), 
you can connect a PC to its console port using a DB-9 to RJ-45 serial cable. Follow these steps to open 
the CLI by connecting to the access point console port:

Connect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 serial port on the access point and 
to the COM port on a computer. 

 shows the serial port connection.

RJ-45 serial

connector

DB-9 to RJ-45

serial cable

74005