Cisco Systems 102053 Manual De Usuario
C I S C O C O N F I D E N T I A L - D r a f t 2
6-7
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-03
Chapter 6 Mounting Instructions
Attaching the Access Point to the Mounting Bracket
Step 5
Adjust the height of the T-bar box hanger to provide antenna clearance above the ceiling tile using the
height adjusting screws (refer to
height adjusting screws (refer to
).
Step 6
Attach the T-rail clips on each end of the T-bar box hanger to the ceiling grid T-rails. Make sure the clips
are securely attached to the T-rails.
are securely attached to the T-rails.
Step 7
Connect a drop wire to a building structural element and through the hole provided in the bracket
mounting clip. This additional support is required in order to comply with the U.S. National Electrical
Safety Code.
mounting clip. This additional support is required in order to comply with the U.S. National Electrical
Safety Code.
Step 8
Attach the access point to the access point mounting bracket (refer to the
section.
Step 9
Connect the Ethernet cables to the access point.
Note
The access point power module and power injector are not rated for mounting above suspended
ceilings. Therefore, you must use the Ethernet cable to supply power.
ceilings. Therefore, you must use the Ethernet cable to supply power.
Step 10
If you need additional security, you can secure the access point to a nearby immovable object using a
Kensington lock and security cable.
Kensington lock and security cable.
Step 11
Verify that the access point is operating before replacing the ceiling tile.
Attaching the Access Point to the Mounting Bracket
Follow these steps to attach the access point to the mounting bracket:
Step 1
Line up the three mounting pins on the access point with the large ends of the keyhole-shaped holes on
the mounting bracket.
the mounting bracket.
Step 2
Insert the access point into the keyhole shaped holes and maintain a slight pressure to hold it in place.
Step 3
Slide the access point’s mounting pins into the small ends of the keyhole-shaped holes on the mounting
bracket and push the connector end of the access point. You will hear a click when the locking detent
contacts the access point and locks it into place.
bracket and push the connector end of the access point. You will hear a click when the locking detent
contacts the access point and locks it into place.
Step 4
Attach and adjust the antenna(s) or antenna cables.
Step 5
Connect the Ethernet cable to the access point’s Ethernet port.
Step 6
If using local power, insert the 1200 series power module cable connector into the access point’s 48-VDC
power port.
power port.
Securing the Access Point to the Mounting Bracket
The security hasp on the mounting bracket enables you to lock the access point to the bracket to make it
more secure. When the access point is properly installed on the mounting bracket, the holes in the
security hasps line up so you can install a padlock.
more secure. When the access point is properly installed on the mounting bracket, the holes in the
security hasps line up so you can install a padlock.
Known compatible padlocks are Master Lock models 120T or 121T.