Cisco Systems 102053 Manual De Usuario

The 802.11g radio upgrade kit ships with the following labels for the 1100 and 1200 series access points:

1100 series access point upgrade label (AIR-1121G-x-K9 UPGRADE)—not used on the 1200 series 
access point.

1200 series product compliance label (AIR-AP1231G-x-K9)

1200 series radio compliance label (AIR-MP21G-x-K9)

 shows where to place the labels on your 1200 series access point, based on the model you are 

upgrading. Follow these steps to place the labels correctly:

Check the product compliance label to identify the model number of your 1200 series access point.

Use the matrix in 

 to decide which labels to use and where to place them on the access point.

Discard any labels that you did not use.

The radio card installation is now complete. To configure the radio with your wireless network settings, 
refer to the Cisco IOS Software Configuration Guide for Cisco Aironet Access Points.

To find the version of IOS software running on your access point, use a Telnet session to log into the 
access point and enter the show version EXEC command. This example shows command output from 
an access point running Cisco IOS Release 12.2(11)JA: 

ap1200>show version 

Cisco Internetwork Operating System Software 

IOS (tm) C1200 Software (C1200-K9W7-M), Version 12.2(11)JA 

Copyright (c) 1986-2003 by Cisco Systems, Inc. 

On access points running IOS software, you can also find the software version on the System Software 
page in the access point's web-browser interface. 

If your access point does not run IOS software, the software version appears at the top left of most pages 
in the web-browser interface. 

AIR-AP1200

Place over existing AIR-MP20B-x-K9 
radio compliance label or location 2 if no 
label exists.

—

AIR-AP1210

AIR-AP1220A

AIR-AP1230A

AIR-AP1220B

—

Place over existing AIR-AP12xx-x-K9 
product compliance label.

AIR-AP1230B