Cisco Systems 102053 Manual De Usuario

Click the Reset to Defaults button.

If the access point is configured with a static IP address, the IP address does not change.

After the access point reboots, you must reconfigure the access point by using the Web browser interface, 
the Telnet interface, or IOS commands.

If your access point has a firmware failure, you must reload the complete access point image file using 
the Web browser interface or by pressing and holding the MODE button for around 30 seconds. You can 
use the browser interface if the access point firmware is still fully operational and you want to upgrade 
the firmware image. However, you can use the MODE button when the access point has a corrupt 
firmware image. 

Your access point must be running specific Cisco IOS software releases before you upgrade its radios; 
otherwise your access point might not be able to complete the boot sequence until the radio is removed 
(see 

). For additional information, refer to the 

 section.

You can use the MODE button on the access point to reload the access point image file from an active 
Trivial File Transfer Protocol (TFTP) server on your network or on a PC connected to the access point 
Ethernet port. 

If your access point experiences a firmware failure or a corrupt firmware image, indicated by three red 
LEDs, you must reload the image from a connected TFTP server.

This process resets all configuration settings to factory defaults, including passwords, WEP keys, the 
access point IP address, and SSIDs. 

Follow the steps below to reload the access point image file:

The PC you intend to use must be configured with a static IP address between 10.0.0.2 and 10.0.0.30.

IEEE 802.11g

12.2(13)JA or later 

RM21A or RM22A 

12.3(2)JA or later