Gemtek Technology Co. Ltd. AP931229AG Manual De Usuario
BROWAN COMMUNICATIONS
Page
21
Bridge+ Bridge Mode
Bridge + Bridge mode is used in the area without Ethernet wiring.
The typical usage is: 11a Bridge + 11a Bridge for Point to Multi-Point or for wireless Repeater.
Figure 8 – Bridge +Bridge application mode in Point to Multi-Point
Figure 9– Bridge +Bridge application mode as wireless repeater
Because of the antenna interference, the performance will deteriorate dramatically
if the same band (2.4GHz or 5GHz) is used both on the two RF modules.
It is strongly recommended that leave two external antennas apart, at least larger
than 1m. Thus antenna interference can be ignored.
If external antenna cannot be apart, it is strongly recommended that one RF
module is set 2.4GHz and the other is set 5GHz.
if the same band (2.4GHz or 5GHz) is used both on the two RF modules.
It is strongly recommended that leave two external antennas apart, at least larger
than 1m. Thus antenna interference can be ignored.
If external antenna cannot be apart, it is strongly recommended that one RF
module is set 2.4GHz and the other is set 5GHz.