Gilbarco Inc. TCR Manual De Usuario
Pr
el
imina
ry
Installation of the TCR
Page 12
MDE-4770 Tribrid Card Reader Installation Manual · June 2008
Installing the M07999B001 TCR in an Encore S EMV Unit (with Contactless
Card Reader Option)
Card Reader Option)
Removing the Existing Card Reader
To remove the existing Card Reader, proceed as follows:
Note: Read all instructions before beginning and observe all safety precautions.
1
Obtain an approval from the store manager or responsible personnel to remove the unit from
service.
service.
2
Remove AC power to the unit using the station circuit breaker. Refer to MDE-3893 Encore/
Eclipse Owners Manual for details.
Eclipse Owners Manual for details.
3
Remove the lower hydraulics panel. The main door has a lower latch underneath the lower left
main door corner. Open this latch. Locate the upper main door lock. Insert the main door key
and open the main door.
main door corner. Open this latch. Locate the upper main door lock. Insert the main door key
and open the main door.
4
for Side 2 of the unit.
5
on
).
6
Remove the ESD Ground Connection cable from the current Card Reader (if it has one).
7
Use a 1/4 inch nut driver or 1/4 inch ratchet and socket to remove the two Hex head screws
(see
(see
on
) that secure the Card Reader bracket (see
on
) and
the Card Reader to the option door. Dispose of the Card Reader and bracket, unless you want
to keep the Card Reader as a used spare part.
Note: Make a note of the Card Reader’s gasket orientation. This information will be useful
to keep the Card Reader as a used spare part.
Note: Make a note of the Card Reader’s gasket orientation. This information will be useful
when you install the new Card Reader gasket (M00682B001) and bracket
(M07574B001). Also, ensure that the option door has been cleaned with isopropyl
alcohol and a clean cloth prior to installing the new Card Reader gasket
(M00682B001).
(M07574B001). Also, ensure that the option door has been cleaned with isopropyl
alcohol and a clean cloth prior to installing the new Card Reader gasket
(M00682B001).
8
Remove the old Card Reader gasket from the option door. Use a putty knife, if required.