Bendix Commercial Vehicle Systems LLC TX433TS-2 Manual De Usuario

 
SmarTire Systems Inc.  
Tire Monitoring System Reference Manual

 

 

 

 6/13/2000     Page 28 of 55 

 
 
Stand-By Mode 
 
The stand-by mode is the state of the multi-function display showing the system status, i.e. 
whether or not data has been received from installed transmitters. The screen is blank if no data 
has been received from any transmitter. A button must be pressed in this mode to enter the other 
modes. Specific data for a selected wheel position is obtained in the regular mode.  
 
 
No data has been received from any installed transmitter. 

 

The outline of an axle is displayed if at least a tire of that axle has a 
pressure or temperature transmission.   

 

The tire with pressure or temperature data received is filled in.  The 
outline of a tire with sensor fault flashes.  If at least one of the ten 
tires of the towing vehicle has a transmission, the louver and the 
windshield are shown. 
 

 

 
 
 
Regular Mode 
 
This mode displays the specific pressure, temperature and alert condition of a selected wheel 
position. The display can be set to show pressure in PSI or BAR and temperature in ºC or ºF. 
Icons indicate the type of alert or warning. 
 
From Stand-By mode press the TIRE button to enter the regular mode. Press the TIRE button to 
cycle through the tires. Press the MODE button to cycle through the pressure, temperature, and 
pressure deviation readings for a selected tire.   
 
The alarm light will turn on if a tire with pressure or temperature problem is selected, and the 
appropriate warning icons are displayed.  Press the SET button or the TIRE and MODE buttons 
together to go back to Stand-By mode.  If no button is pressed in 5 minutes, the system will go 
back to Stand-By mode. 
 
A wheel position that has not transmitted data cannot be selected even if it was previously 
programmed to accept a transmitter.  The tire outline flashes when a sensor fault was detected.