Bendix Commercial Vehicle Systems LLC TX433TS-2 用户手册
SmarTire Systems Inc.
Tire Monitoring System Reference Manual
6/13/2000 Page 28 of 55
This manual is under review by SmarTire – DO NOT ISSUE
Stand-By Mode
The stand-by mode is the state of the multi-function display showing the system status, i.e.
whether or not data has been received from installed transmitters. The screen is blank if no data
has been received from any transmitter. A button must be pressed in this mode to enter the other
modes. Specific data for a selected wheel position is obtained in the regular mode.
No data has been received from any installed transmitter.
The outline of an axle is displayed if at least a tire of that axle has a
pressure or temperature transmission.
pressure or temperature transmission.
The tire with pressure or temperature data received is filled in. The
outline of a tire with sensor fault flashes. If at least one of the ten
tires of the towing vehicle has a transmission, the louver and the
windshield are shown.
outline of a tire with sensor fault flashes. If at least one of the ten
tires of the towing vehicle has a transmission, the louver and the
windshield are shown.
Regular Mode
This mode displays the specific pressure, temperature and alert condition of a selected wheel
position. The display can be set to show pressure in PSI or BAR and temperature in ºC or ºF.
Icons indicate the type of alert or warning.
From Stand-By mode press the TIRE button to enter the regular mode. Press the TIRE button to
cycle through the tires. Press the MODE button to cycle through the pressure, temperature, and
pressure deviation readings for a selected tire.
The alarm light will turn on if a tire with pressure or temperature problem is selected, and the
appropriate warning icons are displayed. Press the SET button or the TIRE and MODE buttons
together to go back to Stand-By mode. If no button is pressed in 5 minutes, the system will go
back to Stand-By mode.
A wheel position that has not transmitted data cannot be selected even if it was previously
programmed to accept a transmitter. The tire outline flashes when a sensor fault was detected.