Data Critical Corporation AVTS1010 Manual De Usuario
AlarmView™ System User’s Guide
{insert part #} Page 29
3. Press and hold transmitter On/Off button until an All Pagers
confirmation message is received at pagers (approximately 5
seconds).
seconds).
Bed: 1234
Programming OK
All Pagers
Programming OK
All Pagers
Programming New Data into Transmitter
Bed number and pager assignment changes made in the
previous steps should now be programmed into the transmitter.
Bed number and pager assignment changes made in the
previous steps should now be programmed into the transmitter.
!
!
!
!
!
!
Once data has been retrieved for a transmitter, it is easiest to
change all values for that transmitter before sending changes
back to transmitter.
change all values for that transmitter before sending changes
back to transmitter.
1. Aim infrared port on programmer directly at infrared port on
front of transmitter and tap SEND button. Programmer will
display “Sending Program Data” status message.
display “Sending Program Data” status message.
{Insert pager screen with “sending program data” message}
Sending Program Data Status Message
2. When transmitter has been successfully programmed,
programmer will display a “Programming Successful” status
message.
message.
{Insert pager screen with “Programming Successful” message}
Programming Successful Status Message
3. Tap Exit button (< in upper right corner) to return to SysMgr.