Accton Technology 3CRWE454G72 Manual De Usuario

■

Check that the Access Point is connected to your switch or hub and 
that all the equipment is powered on. Check that the LAN port link 
status LED on the Access Point are illuminated, and that any 
corresponding LEDs are also illuminated.

■

Ensure that the computers have completed their start-up procedure 
and are ready for use. Some network interfaces may not be correctly 
initialised until the start-up procedure has completed.

■

If the link status LED does not illuminate for the LAN port, check that 
you do not have a faulty cable. Try a different cable. Check also that 
the Uplink/Normal switch is in the correct position.

If you have connected your Access Point, admin computer and switch 
together but cannot browse to the Access Point configuration screens, 
check the following:

■

Confirm that the physical connection between your computer and the 
Access Point is OK, and that the link status LEDs on the Access Point 
and NIC are illuminated and indicating the same speed (10Mbps or 
100Mbps). Some NICs do not have status LEDs, in which case a 
diagnostic program may be available that can give you this 
information.

■

Ensure that your computer is configured correctly. Make sure that the 
computer can communicate with other devices on the network. 
Ensure that the NIC is configured for autonegotiation.

■

Ensure that you do not have a Web proxy enabled on your computer. 
Go to the Control Panel and click on Internet Options. Select the 
Connections tab and click on the LAN Settings button at the bottom. 
Make sure that the Use Proxy Server option is unchecked.