Accton Technology 3CRWE454G72 Manual De Usuario
66
C
HAPTER
6: T
ROUBLESHOOTING
■
When entering the address of the Access Point into your web browser,
ensure that you use the full URL including the http:// prefix (e.g.
ensure that you use the full URL including the http:// prefix (e.g.
http://192.168.1.1
).
■
If you cannot browse to the Access Point, re-run the DISCOVERY
software described in
software described in
to discover the Access Point and the
IP address it has been allocated from the DHCP server. If there is no
DHCP server on your network, the DISCOVERY software changes the
IP address of the Access Point so that it is in the same subnet as your
admin computer.
DHCP server on your network, the DISCOVERY software changes the
IP address of the Access Point so that it is in the same subnet as your
admin computer.
Forgotten
Password and Reset
to Factory Defaults
Password and Reset
to Factory Defaults
If you can browse to the Access Point configuration screen but cannot log
on because you do not know or have forgotten the password, follow the
steps below to reset the Access Point to it’s factory default configuration.
on because you do not know or have forgotten the password, follow the
steps below to reset the Access Point to it’s factory default configuration.
CAUTION: All your configuration changes will be lost, and you will need
to run the configuration wizard again before you can re-establish your
wireless network. All other computer users will lose their network
connections whilst this process is taking place, so choose a time when
this would be convenient.
to run the configuration wizard again before you can re-establish your
wireless network. All other computer users will lose their network
connections whilst this process is taking place, so choose a time when
this would be convenient.
1 Remove power from the Access Point.
2 Hold down the Reset button on the rear of the unit and re-apply power
to the Access Point. The Alert LED will flash as the Access Point starts up,
and after approximately 30 seconds will start to flash more slowly
(typically 2 seconds on, 2 seconds off). Once the Alert LED has started to
flash slowly. Keep Reset button held down and remove power from the
Access Point.
and after approximately 30 seconds will start to flash more slowly
(typically 2 seconds on, 2 seconds off). Once the Alert LED has started to
flash slowly. Keep Reset button held down and remove power from the
Access Point.
3 Release the Reset button.
4 Re-apply power to the Access Point, and when the start-up sequence has
completed, browse to the IP address of the Access Point and run the
configuration wizard. You may need to restart your computer before you
attempt this.
configuration wizard. You may need to restart your computer before you
attempt this.
5 When the configuration wizard has completed, you may reconnect your
network as it was before.
Wireless
Networking
Networking
■
Ensure that you have a Wi-Fi certified 802.11b or 802.11g wireless
adapter for each wireless computer, and that it is correctly installed
and configured. Verify that each Wireless computer has either
Windows 95 or higher or MAC OS 8.5 or higher.
adapter for each wireless computer, and that it is correctly installed
and configured. Verify that each Wireless computer has either
Windows 95 or higher or MAC OS 8.5 or higher.