Braemar Manufacturing LLC FUSIONMCT Manual De Usuario
Fusion Wireless Recorder
5
Setup Steps
DO NOT ENROLL PATIENT IN SOFTWARE UNTIL INSTRUCED
TO DO SO
TO DO SO
This manual is designed to allow a technician to follow the instructions
page by page to setup the Fusion recorder. Here is the general layout:
page by page to setup the Fusion recorder. Here is the general layout:
The Fusion recorder is preprogrammed from the factory for default
settings. The device is fully programmable through the Fusion Wireless
Monitoring System Software. Please refer to the Fusion Wireless
Monitoring System Software for programming capabilities and options
settings. The device is fully programmable through the Fusion Wireless
Monitoring System Software. Please refer to the Fusion Wireless
Monitoring System Software for programming capabilities and options
1. If the recorder contains batteries, and/or a cable remove them and
insure the screen is blank before proceeding
2. Install fresh batteries into recorder. Install only AA Lithium battery
packs provided by Braemar. Observe proper battery polarity when
installing. The battery indicator resets to indicate a full capacity
battery each time the batteries are inserted. For an accurate
indication you must install fresh unused batteries.
installing. The battery indicator resets to indicate a full capacity
battery each time the batteries are inserted. For an accurate
indication you must install fresh unused batteries.
3. Inspect LCD Screen. There are several screens that you may be
greeted with when powering on a recorder. This section covers each
of those screens.
of those screens.
“No cable” screen: The recorder does not have any previous
patient data and you can proceed to step 4.
patient data and you can proceed to step 4.
“Recording…” screen: The recorder is still recording data, you
must stop the recording and erase all the data before setting up
the recorder for the next patient.
must stop the recording and erase all the data before setting up
the recorder for the next patient.
Press the left and right buttons together and it will
prompt you if you want to stop the recording.
prompt you if you want to stop the recording.
Press the Enter button to stop recording the data and
the “Recording Complete” screen will appear.
the “Recording Complete” screen will appear.
Continue to erase the data by following the “Recording
Complete” screen steps.
Complete” screen steps.
Fusion Wireless Recorder
6
“Recording Complete” screen: The recorder still has data in it,
you must erase all the data before setting up for the next patient.
you must erase all the data before setting up for the next patient.
Press the left and right buttons together and it will
prompt you to “Erase Data”.
prompt you to “Erase Data”.
Press the Enter button to erase the data. The display
will have the message “Recorder Empty”.
will have the message “Recorder Empty”.
Continue setting up the recorder by following to the
“Recorder Empty” screen steps.
“Recorder Empty” screen steps.
“Recorder Empty” screen: The recorder is ready to be reset.
Remove the batteries
Return to step 2
4. Apply electrodes to patient
5. Connect snaps to electrodes
6. Plug cable into recorder
7. Observe LCD main menu screen
8. Verify lead status to be OK as described below
9. Verify ECG signal is OK as described below
10. Remove Batteries
11. Enroll patient on software via Enrollment Tab using the Fusion
Wireless Monitoring System Software
12. Verify Enrollment by looking for yellow dot in the Patients Tab
using the Fusion Wireless Monitoring System Software
13. Insert Batteries into the Fusion recorder
14. Verify the recording starts automatically by inspecting the LCD for
the Recording…. screen
15. Verify yellow dot has been changed to two green dots in the Patients
tab using the Fusion Wireless Monitoring System Software
16. Set up is complete and the recoding has been successfully started