Zebra Technologies Corporation MD-ZLAN11G Manual De Usuario
27
Printer Setup
Preparing the Printer for Use
4/23/08
HC100 User Guide
61207L-001 Rev. A
Preparing the Printer for Use
To prepare the printer for use, select an appropriate location for the printer, connect the
appropriate cables to the printer, turn on the printer power, and then select and insert a media
cartridge.
appropriate cables to the printer, turn on the printer power, and then select and insert a media
cartridge.
Site Selection
Select a solid, level surface within reach of an available power outlet. To allow for proper
ventilation and cooling, leave open space on all sides of the printer.
ventilation and cooling, leave open space on all sides of the printer.
Connect to Data Communication Interfaces
Select a data communication interface that is supported by both your printer and your
computer or your Local Area Network (LAN). You may send wristband formats to the printer
through any of its data communication ports.
computer or your Local Area Network (LAN). You may send wristband formats to the printer
through any of its data communication ports.
shows the location of the data communication ports.
provides basic
information about the data communication interfaces.
Figure 11 • Data Communication Ports
Caution •
Do not place any padding or cushioning material under the unit or next to the
back of the unit. This can prevent proper cooling and cause the unit to overheat.
1
Serial port
2
Optional ZebraNet 10/100 Internal Print Server
(wired Ethernet) port
(wired Ethernet) port
3
USB port
Caution •
Be careful not to plug a USB cable into the optional 10/100 wired Ethernet port
on the printer. Doing so will damage the connector. The 10/100 wired Ethernet port comes
with a plastic plug to protect it from accidental damage.
with a plastic plug to protect it from accidental damage.
1
2
3