Zebra Technologies Corporation MD-ZLAN11G Manual De Usuario
Advanced User Information
Additional Diagnostics Tools
Additional Diagnostics Tools
72
61207L-001 Rev. A
HC100 User Guide
4/23/08
Additional Diagnostics Tools
The media sensor profile and the communications diagnostics test are available as diagnostic
tools.
tools.
Media Sensor Profile
Use the media sensor profile to troubleshoot the following types of problems:
• If the media sensor experiences difficulty in determining where wristbands start and stop.
• If the media sensor incorrectly identifies a preprinted area on a wristband as the end of the
wristband.
The media sensor readings are shown as peaks and flat areas on the media sensor profile
(
(
). Two peaks appear when the sensors are operating properly, indicating that the
sensors correctly detected the black mark on the back of the wristband. A media sensor profile
prints on two wristbands.
prints on two wristbands.
Figure 15 • Media Sensor Profile
To print a media sensor profile, complete these steps:
1.
Make sure that the printer is on (I) and ready to print.
2.
Press and hold
PAUSE/FEED
until the green lights turn off on the printer status indicator
and the orange lights blink once. Continue holding
PAUSE/FEED
until the orange lights
blink twice.
3.
Release
PAUSE/FEED
.
A media sensor profile prints.
MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDI
IA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA MEDIA
100
80
60
40
20
0