ZyXEL Communications Corporation G570SV2 Manual De Usuario

 Chapter 7 Wireless Screens

ZyXEL G-570S

 v2 User’s Guide

In a wireless network, the wireless clients must have the same SSID and security settings as 
the access point (AP) or wireless router (we will refer to both as “AP” here) in order to 
associate with it. Traditionally this meant that you had to configure the settings on the AP and 
then manually configure the exact same settings on each wireless client.

OTIST (One-Touch Intelligent Security Technology) allows you to transfer your AP’s SSID 
and WEP or WPA-PSK security settings to wireless clients that support OTIST and are within 
transmission range. You can also choose to have OTIST generate a WPA-PSK key for you if 
you didn’t configure one manually.

"

OTIST replaces the pre-configured wireless settings on the wireless clients.

"

OTIST is not available in AP+Repeater or Bridge mode at the time of writing.

You must enable OTIST on both the AP and wireless client before you start transferring 
settings.

"

The AP and wireless client(s) MUST use the same Setup key.

You can enable OTIST using the OTIST button or the web configurator. 

If you use the OTIST button, the default (01234567) or previous saved (through the web 
configurator) Setup key is used to encrypt the settings that you want to transfer. 

Hold in the OTIST button for one or two seconds. 

Click Wireless > OTIST  in AP, AP+Repeater or Bridge mode to configure and enable 
OTIST. The screen appears as shown.