ZyXEL Communications Corporation NBG418NV2 Manual De Usuario

Chapter 4 Modes

Connect your computer to the LAN port of the NBG-418N. 

The default LAN IP address of the NBG-418N is 192.168.1.1 in router mode (192.168.1.2 by default 
in non-router mode). In router mode, the NBG-418N can assign your computer an IP address, so 
you must set your computer to get an IP address automatically (computer factory default) or give it 
a fixed IP address in the range between 192.168.1.3 and 192.168.1.254.

After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and 
type the IP address of the NBG-418N as the web address in your web browser.

Log into the Web Configurator. See the 

 for instructions on how to do this.

Go to Maintenance > Sys OP Mode > General and select Client Bridge.

Maintenance > Sys OP Mode > Client Bridge 

A pop-up window appears providing information on this mode. Click OK in the pop-up message 
window. Click Apply. Your NBG-418N is now in Client Bridge mode.

Tools

Firmware

Use this screen to upload firmware to your NBG-418N.

Configuration

Use this screen to backup and restore the configuration or reset the 
factory defaults to your NBG-418N. 

Restart

This screen allows you to reboot the NBG-418N without turning the power 
off.

Sys OP Mode

General

This screen allows you to select the device operation mode: Router, 
Access Point, Client Bridge or Universal Repeater.

Language

Language

This screen allows you to select the language you prefer.

Menu: Universal Repeater Mode (continued)