ZyXEL Communications Corporation WRE6505 Manual De Usuario

 Chapter 12 Troubleshooting

WRE6505 User’s Guide

If you reset the WRE6505, you lose all of the changes you have made. The WRE6505 re-loads its 
default settings, and the username/password resets to admin/1234. You have to make all of your 
changes again.

You will lose all of your changes when you reset the WRE6505 to its factory defaults.

To reset the WRE6505,

Make sure the power LED is on.

Press the WPS button for longer than 10 seconds, the Power LED begins to blink, to set the 
WRE6505 back to its factory-default configuration.

OR

Click Maintenance > Backup/Restore > Restore and then click Reset.

If the WRE6505 restarts automatically, wait for the WRE6505 to finish restarting, and log in to the 
Web Configurator. The username is admin and password is 1234.

If the WRE6505 does not restart automatically, disconnect and reconnect the WRE6505’s power. 
Then, follow the directions above again.

I cannot access the WRE6505 or ping any computer from the WLAN.

Make sure the wireless LAN is enabled on the WRE6505.

Make sure the wireless adapter on the wireless station is working properly.

Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible and supports 
the same wireless standard as the WRE6505.

Make sure your computer (with a wireless adapter installed) is within the transmission range of the 
WRE6505.

Check that both the WRE6505 and your wireless station are using the same wireless and wireless 
security settings, and that both the WRE6505 and the AP are using the same wireless and wireless 
security settings.

Make sure traffic between the WLAN and the LAN is not blocked by the MAC Address List of the 
WRE6505. See 

.