ZyXEL Communications Corporation WRE6505 Manual De Usuario
Chapter 9 Wireless LAN
WRE6505 User’s Guide
57
Figure 43
Network > Wireless LAN (2.4G/5G) > AP Select (Repeater Mode)
The following table describes the labels in this screen.
9.7 MAC Filter
The MAC Filter screen allows you to specify which devices are allowed to access the WRE6505,
while denying access to all unspecified devices. Every Ethernet device has a unique MAC (Media
Access Control) address. The MAC address is assigned at the factory and consists of six pairs of
while denying access to all unspecified devices. Every Ethernet device has a unique MAC (Media
Access Control) address. The MAC address is assigned at the factory and consists of six pairs of
Table 19
Network > Wireless LAN (2.4G/5G) > AP Select (Repeater Mode)
LABEL
DESCRIPTION
Select
Use the radio button to select the wireless device to which you want to connect.
SSID
This displays the Service Set IDentity of the wireless device. The SSID is a unique name
that identifies a wireless network. All devices in a wireless network must use the same
SSID.
that identifies a wireless network. All devices in a wireless network must use the same
SSID.
MAC
This displays the MAC address of the wireless device.
Channel
This displays the channel number used by this wireless device.
Mode
This displays which IEEE 802.11b/g/n wireless networking standards the wireless device
supports.
supports.
Security Mode
This displays the type of security configured on the wireless device. When no is shown, no
security is configured and you can connect to it without a password.
security is configured and you can connect to it without a password.
Strength
This displays the strength of the wireless signal. The signal strength mainly depends on
the antenna output power and the distance between your WRE6505 and this device.
the antenna output power and the distance between your WRE6505 and this device.
<
Click < to see the previous page of APs.
>
Click > to see the next page of APs.
Setup repeater
manually
manually
Select this to setup the AP manually.
SSID
If Setup repeater manually is selected, use this field to type the SSID of the AP. This is
useful when the AP’s SSID is hidden.
useful when the AP’s SSID is hidden.
Refresh
Click Refresh to search for available wireless devices within transmission range and
update this table.
update this table.
Next
Click Next to start the next step in the AP setup process.