Applied Concepts Inc ACMI007 Manual De Usuario
Applied Concepts 011-0131-00 rev 2
Page 12
5 Sensor configuration
5.1.1.1.1.1.1 Configuration Setting Descriptions
All the control and configuration settings available for the Speed Sensors are described
in this Appendix. Here, they are arranged in the following groups of related function.
1. Basic Configuration
2. Serial Port Configuration
3. Target Recognition
4. Target Filtering
5. Speed Presentation
6. Locking Targets
7. Speed Alarm
8. Audio
9. TX Power Save
10. Testing
11. System
2. Serial Port Configuration
3. Target Recognition
4. Target Filtering
5. Speed Presentation
6. Locking Targets
7. Speed Alarm
8. Audio
9. TX Power Save
10. Testing
11. System
Not all settings are available in all models. The table in Appendix D lists all the settings
in order of ID number. It shows all possible values, which settings are available for each
model and the default value for each model. Refer to the table while reading this section
for a better understanding of the settings.
1. Basic Configuration
SETTING
ID
Transmitter Control
42
Mode
1
Zone
2
Units
20
Unit Resolution
21
Faster Target Tracking
13
AUX Pin Configuration
16
The Transmitter Control setting (42) turns the radar transmitter on or off and is
available in all models. The transmitter must be on for the radar to register speeds.
The Mode setting (1) can only be changed in the Traffic Speed Sensor model. It is used
to select between moving mode or stationary mode. The Stationary Speed Sensor
models are fixed in stationary mode, and the Speedometer Speed Sensor models are
fixed in moving mode.
The Zone setting (2) tells the radar what zones to look for targets in.
When in stationary mode, the Zone values are Away to monitor receding targets only,
Closing to monitor approaching targets only and Both to monitor targets moving in either
direction.