Risco Ltd. RWT312PR4 Manual De Usuario
Installation
Instructions
7
English
Changing Back Tamper position
The back tamper is by default secured on the right
side of the internal base (Rear view). If you wish to
move it to the left side (rear view), do the following
(Figure 5):
side of the internal base (Rear view). If you wish to
move it to the left side (rear view), do the following
(Figure 5):
1. Remove tamper screw 1 in order to release the
tamper from position 7.
2. Ensure tamper spring (2) rests over tamper wire
base 4.
3. Ensure plastic tamper bracket (3) rests over
both 2 and 4.
4. Secure tamper screw (1) into (3) over position 6.
Figure 5
Left
Side
Tamper
Right
Side
Tamper
3
6
1
2
4
7
5
Figure 5
Notes:
1. Verify that you hear a "Click" when attaching the tamper spring to the wall.
2. For pole installation, the tamper can be moved to the bottom right-hand side of the internal base.
2. For pole installation, the tamper can be moved to the bottom right-hand side of the internal base.
Back Tamper Terminal Wiring
If you wish to use the back tamper (recommended) remove the short from the back tamper terminal
block and connect the back tamper wires to the back tamper terminal block.
block and connect the back tamper wires to the back tamper terminal block.
Back Tamper in use
BACK TAMPER
Back Tamper not used
Short
H1
H1
DIP Switch Settings
1 2 3 4 5 6
ON
Factory
Default
DIP 1: LEDs operation
On: LEDs enabled
Off: LEDs disabled
Off: LEDs disabled
DIP 2-3: PIR Detection Sensitivity
Sensitivity
DIP2
DIP3
Low Off
Off
Mid Off
On
Normal
On
Off
Maximum On On
DIP 4: Supervision time
On: 65 minutes
Off: 15 minutes
Off: 15 minutes
DIP 5: Normal/Test modes
On: Test
Off: Normal
Off: Normal
DIP 6: Anti masking operation
On: Enabled
Off: Disabled
Off: Disabled