Benq Corporation WDP02T Manual De Usuario

Installation

4. Press

SOURCE

button on the remote control or on the top of the receiver/the transmitter for

source input switching until you see the video being transmitted.

Performing IR sync

The default IR blaster frequency setting is 47KHz, which is compatible with most remote controls.
With the connected IR blaster cable, it relays infrared commands from your remote control to the
connected source devices. After all the devices have been installed and powered on, you should be
able to control your source devices by pointing their remote control to the receiver. If one of your
source devices does not respond, follow the procedures to perform IR sync to set the IR frequency.

1. Place two AAA batteries into the remote control of the receiver/transmitter.

2. Make sure that the IR blaster cable has been connected with source devices and transmitter. See

Setting up the transmitter (Tx) on page 10

for details.

3. Make sure that the transmitter, receiver, and all the connected devices have been properly

connected and powered on, and the desired source has been transmitted. See

Powering up all

devices and making source selection on page 16

for details.

4. Press the

button on the receiver’s remote control. The current IR frequency is displayed.

Press the