Benq Corporation WDP02T Manual De Usuario

  19

  Basic operations and on-screen display (OSD)

Basic operations and on-screen display (OSD)

Only the status of the receiver connected to the projector can be displayed on the OSD. The status of the 
transmitter HDMI out cannot be displayed.

Function

Operations

OSD display

Both Rx and 
Tx enter 
standby mode, 
while Tx’s 
HDMI out is 
on

In active mode, press the power button on the 
top of the receiver / transmitter or on the 
remote control pointing to the receiver, both the 
transmitter and the receiver will enter standby 
mode while the transmitter’s HDMI out is still 
on. 

 

(display for 3 seconds and then 
enter standby mode.)

Shows display 
information

Press the 

 button on the remote control, 

and information such as signal quality, source, 
channel, and resolution will be displayed for 
reference.
Press the 

 button again to exit.

 

Audio / video 
source input 
selection

Press the 

 button on the remote 

control or on the top of the transmitter (or the 
receiver) for audio/video source input selection. 

Example: 

 

Change IR 
blaster 
frequency

Press the 

 button of the remote control to 

change IR blaster frequency between 36KHz and 
56KHz. The default IR blaster frequency setting 
is 47KHz.
• Press once for current IR frequency status 

display.

• Press again to switch IR blaster frequency.

Example: 

 

 =