CALAMP WIRELESS NETWORKS INC. BDP4-EXCT769 Manual De Usuario
001-2019-500 Rev 0
Paragon4 – UHF, 700 & 800MHz User Manual
14
5.1.2 Exciter module
The Exciter’s front panel controls and indicators are:
LED indicators, according to the table below.
*
The cause of Fault or Warning conditions will be displayed on the Unit Status web page
and recorded in the MaintenanceSystem Log.
Carrier test - momentarily keys the transmitter ON while pressed (used for test purposes only). If the
Carrier is pressed for 4 seconds or more the exciter starts the test mode and keeps transmitting until
the next press of the button.
the next press of the button.
One DE-9 RS-232 ports for setup.
5.1.3 BSC2 Module
The BSC2's front panel connectors and indicators are:
Green
Red
Flashing Amber
Off
Power
Normal
Fault *
Warning *
TX
Idle (un-
keyed)
keyed)
Normal
Mode:
Transmitting
in normal
mode
Mode:
Transmitting
in normal
mode
Test Mode:
transmitting in
test mode
transmitting in
test mode
Idle
10 MHz 10 MHz
Locked
10 MHz con-
nection bro-
ken, unable to
lock
nection bro-
ken, unable to
lock
Acquiring 10
MHz Lock
MHz Lock
Idle if 10
MHz was
never con-
nected.
MHz was
never con-
nected.
Lock
Synth lock,
Normal
Normal
Synth unlock
Fault
Fault
Programming
mode
mode
PWR
LED
LED
Green
Normal operation
Red
Bootstrap step 1 – lights for <5 sec.
Amber
Bootstrap step 2 – lights for <5 sec.
Red
flashing
Hardware error, check Unit Status web page
RX LED
Green
Flashes for each data packets received
Red
Discard RX packet (factory-use)
TX LED
Green
Flashes for each data packet transmitted
Amber
Flashes for each data packet transmitted
(check for lost Host connection on Unit Stat
web page)
Red
Continuously ON during TXON test (max.
20 sec)
Flashes during CWID key-down
Off
When AirLink down selected by PF rocker
switch
STATUS
Green
Flashes each time PF1 or PF2 is pressed
Amber
Flashes each second PF1 is kept pressed
Toggles “AirLink down mode” after 4
seconds
LOCK
PWR
TX
Ext. 10MHz
COM
Carrier Test
SDR
Exciter